Insulating a loft, ceiling or wall: enter the area and the R-value you are aiming for, choose batts/rolls or blown-in, and get how many packs or bags to buy — plus the approximate thickness that reaches your target for the material you pick.
It depends on the element and your climate/building code. As a rough guide: uninsulated loft ceilings are often brought to R-30 to R-60 (RSI 5.3–10.6) in cold climates, walls to R-13 to R-21. Check your local energy code — it sets the legal minimum for new work.
They measure the same thing — resistance to heat flow. R-value is the imperial unit; RSI is the metric unit used in Europe and Canada. RSI = R × 0.176, so R-20 is RSI 3.5 and a European 'R' printed on EU products is actually RSI in disguise.
Blown-in coverage charts are based on settled density: to reach a higher R in the same square meter you need more material depth, so each bag is spread thinner over fewer square meters. Always read the coverage row that matches your target R, not the headline figure.
Packs / bags = ceil( Area × (1 + Waste %) ÷ Coverage per pack/bag )
Thickness ≈ Target value ÷ Material value per unit thickness
R-values add up when layers are combined, and metric RSI converts as R = RSI × 5.678 (RSI = R × 0.176). Typical material performance: fibreglass about R-3.5 per inch (RSI 0.61 per 25 mm), mineral wool R-3.8/inch, blown cellulose R-3.3/inch, EPS board R-4.0/inch.
For batts between joists, yes — a second layer laid across the joists at 90° covers the timber bridging and gaps of the first layer, and performs noticeably better than one thick layer fitted the same way.
Yes. A batt squeezed into a shallower cavity than it was made for loses performance roughly in proportion to the compression. Choose a product made for your cavity depth instead of crushing a thicker one in.
10% covers cuts around joists, pipes and edges for batts and rolls. Blown-in settles a little after installation; installers usually blow 5–10% above the settled target depth, which the same allowance covers.
Add this calculator to your own website or blog — it is completely free, needs no sign-up, and always shows the latest version. Copy the code below and paste it into your page where you want the calculator to appear. Keeping the small “Powered by Loona Automation” credit line under the embed helps keep this tool free — but you are free to style or remove it; the tool works either way.