13 posts, 13 bays — and about 30 bags of concrete, not the handful most guides suggest. The full list is computed below. Fence projects die on under-bought concrete and fasteners. This page counts a standard 100-ft run honestly, hole by hole.
| Posts (4×4, 8 ft) | 13 (one every 8 ft + one to close the run) |
|---|---|
| Panels / rails | 13 bays → 13 pre-built 8-ft panels, or 26 rails (2 per bay) + ≈340 pickets (5.5 in, ¼ in gap) |
| Concrete for post holes | ≈30 × 80-lb bags total — a 10-in × 30-in hole is ≈1.4 ft³ and a bag yields 0.6 ft³, so 2–3 bags per hole (guides that say a third of a bag are wrong) |
| Gravel for hole bases | ≈0.2 yd³ (2 in per hole) |
| Fasteners | ≈1,360 picket screws (340 pickets × 2 rails × 2 screws) — buy 1,500 |
Post spacing at 8 ft is the panel standard; gates need doubled posts and their own hardware. The concrete line is the one DIY guides understate: a real 10 × 30 in hole is about 1.4 cubic feet, and an 80-lb bag yields 0.6 ft³ — so budget 2–3 bags per hole, as the table does. The Fence Calculator adjusts spacing and length.
Concrete Calculator · Brick Calculator · Tile Calculator · Paint Calculator · Roof Pitch Calculator · Deck Calculator
A 10-in diameter, 30-in deep hole is ≈1.4 ft³; an 80-lb bag makes 0.6 ft³ — so 2–3 bags per hole. Shallow or narrow holes use less but hold less.
Panels are faster (13 to hang); pickets are cheaper and follow slopes (racked). Counts for both are in the table.
Below the frost line locally, commonly 24–36 in, with the bottom 2 in on gravel. Local code and soil decide — this page assumes 30 in.
Add 2 heavier posts (6×6 preferred), hinges and a latch, and brace the gate bay — gates are the first failure point of every fence.